If eg. PCRF or AAA diameter link is not yet ready (eg. PCRF crashed), and
a client sends a CreateSessionRequest announcing its ow F-TEID,
then open5gs-smfd answers with Create Session Response Cause=
"Remote peer not responding", but it is not setting the received F-TEID
in the header of the response, instead it sends with TEI=0.
As a result, the peer cannot match the CreateSessionResponse, and needs
to rely on its own timeout timer to figure out that specific request failed.
This also happens in PFCP, so to solve this problem, I added teid/seid_presence
to the interface that sends the error message as shown below.
void ogs_gtp2_send_error_message(ogs_gtp_xact_t *xact,
int teid_presence, uint32_t teid, uint8_t type, uint8_t cause_value);
void ogs_pfcp_send_error_message(
ogs_pfcp_xact_t *xact, int seid_presence, uint64_t seid, uint8_t type,
uint8_t cause_value, uint16_t offending_ie_value);
Scenario is handover on S1AP, data forwarding is enabled, and
the Source ENB is forwarding DL PDCP packets to EPC(SGWU)
with PDCP SN included. SGWU is also forwarding these packets
to the Target ENB.
However the PDCP SN is not present in the forwarded packets
from SGWU to Target ENB.
I modified this part, and there was the same problem in 5GC, fixed it as well.
A lot of code in GTP-U has been modified,
so if you have any problems, please let us know right away.
TS23.007 17.4.1
19A PFCP based restart procedures
After a PFCP entity has restarted, it shall immediately update all local Recovery Time Stamps and shall clear all remote
Recovery Time Stamps. When peer PFCP entities information is available, i.e. when the PFCP Association is still alive,
the restarted PFCP entity shall send its updated Recovery Time Stamps in a Heartbeat Request message to the peer
PFCP entities before initiating any PFCP session signalling.
In the past only GTPv2C was supported, and had the "gtp" generic prefix.
Later on, GTPv1C support was added, and "gtp1" prefix was used.
Let's move GTPv2C specific bits to have "gtp2" prefix too, and leave
"gtp" prefix for generic stuff among different GTP versions.
* Flow-Description use 'to assigned' in Gx Interface
* Support SDF Filter ID
* Support F-TEID's Choose
* BAR(Buffering) is added in PFCP session
* Default Apply Action uses NOCP|BUFF
So far, no operation was performed when Error Indication was received
from eNodeB. For that reason, I solved #568 issues by controlling
the MME to prevent this from happening.
Now, when GTP-U Error Indication is received, MME and SGW are implemented
to do what they have to do. I hope that the network can be restored
by responding appropriately even if Error Indication occurs.