Assume the UE has Attached, the session has been created,
and is in the IDLE state with the UEContextRelease process.
This could result in the following call flow.
1. TAU request without Integrity Protected
2. Authentication request/response
3. Security-mode command/complete
MME can be performed simultaneously by the HSS(S6A) and UE(S1AP).
Update-Location-Request
Service request
Service reject
Delete Session Request
Delete Session Response
Update-Location-Answer
UEContextReleaseCommand for Service reject
TAU reject
UEContextReleaseCommand for TAU reject
UEContextReleaseComplete
UEContextReleaseComplete
MME crashes when UE sends a service request(S1AP) during ULR/ULA(S6A) with HSS,
which has been fixed.
I've resolved an issue where sending continuous
'PDU Session Release Request' message to the same session,
when more than two sessions were created, was causing an SMF crash.
For your reference, this problem did not occur
when only one session was created.
The AMF shall assign a new 5G-GUTI for a particular UE:
a) during a successful initial registration procedure;
b) during a successful registration procedure
for mobility registration update; and
c) after a successful service request procedure invoked as a response
to a paging request from the network and before the release
of the N1 NAS signalling connection as specified in subclause 5.4.4.1.
The AMF should assign a new 5G-GUTI for a particular UE
during a successful registration procedure
for periodic registration update. The AMF may assign a new 5G-GUTI
at any time for a particular UE by performing
the generic UE configuration update procedure.
If both Delete-Session-Request/Response and
UEContextReleaseCommand/UEContextReleaseComplete are failed at the same time,
UE cannot attach to the EPC infinitely.
So, I've add the protection code
if timer expires when MME does not receive Delete-Session-Response.
Sukchan Lee