Assume the UE has Attached, the session has been created,
and is in the IDLE state with the UEContextRelease process.
This could result in the following call flow.
1. TAU request without Integrity Protected
2. Authentication request/response
3. Security-mode command/complete
MME can be performed simultaneously by the HSS(S6A) and UE(S1AP).
Update-Location-Request
Service request
Service reject
Delete Session Request
Delete Session Response
Update-Location-Answer
UEContextReleaseCommand for Service reject
TAU reject
UEContextReleaseCommand for TAU reject
UEContextReleaseComplete
UEContextReleaseComplete
MME crashes when UE sends a service request(S1AP) during ULR/ULA(S6A) with HSS,
which has been fixed.
While they were continuing their fuzzy testing and developing PacketRusher, an unusual issue with the AMF was observed. The problem arises when a single Ethernet frame containing three bundled SCTP chunks is sent. This behavior is reproduced with PacketRusher when attempting to concurrently register two UEs with the same MSIN.
The expected behavior is that the PDU Session Establishment Accept is sent inside a DownlinkNASTransport to RAN UE NGAP ID 1. However, it is actually sent inside an InitialContextSetupRequest to RAN UE NGAP ID 2. The MAC of this NAS message is invalid for the Security Context of RAN UE NGAP ID 2 (probably valid for RAN UE NGAP ID 1)
UDM may send a Deregistration Notification to AMF, to deregister
specific UE from the network - Network-Initiated Deregistration.
Deregistration procedure includes sending Deregistration Request to UE,
starting a timer T3522, releasing PDU sessions from SMF, releasing PCF
policies from PCF, and waiting for Deregistration Accept from UE.
Not yet implemented is:
- to prevent deregistration of UE in case it has any emergency sessions,
- page UE when UE is in IDLE mode.
TS24.501
8.2.11 DL NAS transport
8.2.11.4 5GMM cause
The AMF shall include this IE when the Payload container IE
contains an uplink payload which was not forwarded and
the Payload container type IE is not set to "Multiple payloads".
-0-
As such, this function 'nas_5gs_send_gsm_reject()' must be used
only when an N1 SM message has been forwarded to the SMF.
All process will be forcely exited if it failed to encode the S1AP/NGAP/GTP/PFCP message. It is to make sure there was no problem with the encoding of open5gs.
o Tester
1. UE registered to 5GS and can connect to internet.
2. Turn off the UE and turn on the UE immediately
3. UE send PDU session request message
without sending registration complete
o Analysis Result
1. UE sends registration request with unknown GUTI
2. AMF send registration accept without GUTI
3. UE skips the registration complete
So, we need the handler UL NAS Transport in this state.