diff --git a/documentation/poky.ent b/documentation/poky.ent
index 342865acfd..5aa4da8ba1 100644
--- a/documentation/poky.ent
+++ b/documentation/poky.ent
@@ -47,3 +47,4 @@
+
diff --git a/documentation/yocto-project-qs/yocto-project-qs.xml b/documentation/yocto-project-qs/yocto-project-qs.xml
index b37a45f337..3fde5b7d08 100644
--- a/documentation/yocto-project-qs/yocto-project-qs.xml
+++ b/documentation/yocto-project-qs/yocto-project-qs.xml
@@ -387,7 +387,8 @@
$ wget &YOCTO_POKY_DL_URL;
$ tar xjf &YOCTO_POKY;.tar.bz2
- $ source &OE_INIT_PATH; &YOCTO_POKY;-build
+ $ cd &YOCTO_POKY;
+ $ source &OE_INIT_FILE;
@@ -412,12 +413,15 @@
The second command extracts the files from the tarball and places
them into a directory named &YOCTO_POKY; in the current
directory.
- The third command runs the Yocto Project environment setup script.
- Running this script defines OpenEmbedded build environment settings needed to
+ The third and fourth commands change the working directory to the
+ source directory
+ and run the Yocto Project environment setup script.
+ Running this script defines OpenEmbedded build environment settings needed to
complete the build.
The script also creates the
build directory,
- which is &YOCTO_POKY;-build in this case.
+ which is build in this case and is located in the
+ source directory.
After the script runs, your current working directory is set
to the build directory.
Later, when the build completes, the build directory contains all the files
@@ -426,7 +430,7 @@
Take some time to examine your local.conf file
- in your project's configuration directory.
+ in your project's configuration directory, which is found in the build directory.
The defaults in that file should work fine.
However, there are some variables of interest at which you might look.